Program Your Dish Remote to New TVAs technology continues to evolve, there will probably come a time when you want to upgrade your TV. Replacing your existing television will also require you to re- program your Dish remote in order to access your Dish service. This is an easy process and should not take long to complete. This article will walk you through 4 easy steps to program your Dish remote to your new TV.
Programming a Dish Remote by Code. Before you get started you will need to determine your remote. You can find this in Dish Networks online support section. You will be provided with a list of codes and their success rating. Write these codes down, you will need to reference them later.
Once you have your remote code, follow the steps below to complete remote programming: Point your remote at the TV (it will need to remain pointed at the TV throughout the process) and press and hold the . This should make the TV button light up by itself now (The others will turn off). Press the pound button (#) on your remote, this should make the TV button flash 3 times. Press the power button on the remote. The TV should turn off if the all steps were done correctly.
How to Program Remote to TV or Other Device . The mode button you selected will light up.
If you are programming a code into AUX Mode, you must do the following before entering the device code.
I have provided the TV codes for your DISH remote to program to your Sharp TV. I have also provided instructions on how to program the remote to your TV. Remote codes: 741, 739, 629, 628, 526, 521, 740, 669, and 608.
How to Program a Dish Network Remote. Write down the program code you used for future use. Program a Direct TV Remote Control.